Download  Print this page

Brother Quattro 2 6700D Operation Manual Page 60

Embroidery and sewing machine.
Hide thumbs


Table of Contents
Pivot the spool pin so that it angles upward.
Set the thread spool on the spool pin so that
the thread unwinds from the front of the
a Spool pin
b Spool cap
c Thread spool
d Spool felt
Push the spool cap onto the spool pin as far
as possible, then return the spool pin to its
original position.
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool
pin and cause the needle to break.
• Use the spool cap (large, medium, or small)
that is closest in size to the thread spool. If a
spool cap smaller than the thread spool is
used, the thread may become caught in the slit
on the end of the spool and cause the needle
to break.
• When sewing with fine, cross-wound thread,
use the small spool cap, and leave a small
space between the cap and the thread
a Spool cap (small)
b Thread spool (cross-wound thread)
c Space
While holding the thread with both hands,
pull the thread up from under the thread
guide plate.
a Thread guide plate
While holding the thread in your right
hand, pass the thread through the thread
guide in the direction indicated.
Guide the thread down, up, then down
through the groove, as shown in the
• Look in the upper groove area to check if the
thread catches on the take-up lever visible
inside the upper groove area.
a Look in the upper groove area


Table of Contents


   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:


Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(