Download  Print this page

Brother Quattro 2 6700D Operation Manual Page 354

Embroidery and sewing machine.
Hide thumbs

Advertisement

ERROR MESSAGES
352
This message is displayed
when the machine failed to
recognize the embroidery
positioning mark.
- Confirm that the embroidery
positioning mark is in the
selected area. If problem
persists, see page 215 to
reposition mark.
- Machine failed to recognize
printed positioning mark.
Set "Page Scaling" to "None
(100%)", and try printing the
embroidery positioning
mark again. (see page 226)
This message is displayed
when the machine has
recognized the embroidery
position mark. Remove the
embroidery positioning
sticker and press
to
continue. To remove the
embroidery positioning
sticker more easily, press
. (see page 215)
This message appears when
the built-in camera is being
used to align the embroidery
position, but the embroidery
positioning sticker is too near
an edge or the pattern
extends from the embroidery
frame. Change the
positioning of the embroidery
position sticker, and then try
aligning the position again.
See page 208.
This message is displayed
when the upper thread is
broken or not threaded
correctly, and the "Start/Stop"
button or the "Reverse/
Reinforcement Stitch" button
is pressed.
This message is displayed
when the "Presser Foot Lifter"
button is pushed while the
presser foot lever is raised/
the needle is lowered.
This message is displayed
when the "Start/Stop" button
is pushed to sew Utility
stitches or Character/
Decorative stitches while the
foot controller is connected.
(This message does not
appear when embroidering).
This message is displayed
when the "Start/ Stop" button
is pushed while the machine
is in embroidery edit mode
and a pattern is being edited.
This message is displayed
when there is no stitch or
embroidery pattern selected
and the "Start/Stop" button or
the "Reverse/Reinforcement
Stitch" button is pressed.
This message is displayed
when the bobbin thread is
running out.
This message is displayed
when the memory is full and
the stitch or pattern cannot be
saved.

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(