Download  Print this page

Brother Quattro 2 6700D Operation Manual Page 152

Embroidery and sewing machine.
Hide thumbs

Advertisement

SEWING THE STITCHES
d
Place the edge sewing sheet on top of the
needle plate cover.
Align the guides on the edge sewing sheet with the
sides of the needle plate cover, and then adjust the
position of the edge sewing sheet so that its cutout
aligns with the edges of the opening for the feed dogs.
Position the edge sewing sheet so that there is no gap
between it and the edges of the opening for the feed
dogs.
a Edge sewing sheet
b Guides on edge sewing sheet
c Sides of needle plate cover
a Edge sewing sheet
b Feed dogs
c Between the feed dogs and the edge sewing sheet
Note
• If the metal needle plate is visible between
the feed dogs and the edge sewing sheet,
the fabric may be incorrectly detected by the
built-in camera.
Memo
• Before using the edge sewing sheet, peel off
the transparent sheet. After use, affix the
edge sewing sheet to the transparent sheet
to prevent it from collecting dust.
a Transparent sheet
• Set a fully wound bobbin before starting to
use the edge sewing feature and built-in
camera. If you need to change the bobbin
while edge sewing, remove the edge sewing
sheet carefully and place it again after
changing the bobbin.
150
e
Press
.
→ Depending on the stitch, the straight stitch with the
middle (center) needle position is selected,
regardless of the preset stitch width.
*
Regardless of the setting selected in the machine
settings screen, the brightness of the light changes to
"5".
Note
• After
is pressed, the stitch width and
stitch length cannot be changed. Change
the stitch width and stitch length before
pressing
.
f
When the message shown below appears,
check that the vertical stitch alignment foot
"V" is attached and that the edge sewing
sheet is positioned, and then press
→ Then the edge sewing window appears.
.

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(