Download  Print this page

Attaching The Walking Foot - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

Table of Contents
CHANGING THE PRESSER FOOT
b
Press
buttons.
c
Raise the presser foot lever.

Attaching the Walking Foot

The walking foot holds the fabric between the
presser foot and the feed dogs to feed the fabric.
This enables you to have better fabric control
when sewing difficult fabrics (such as quilted
fabrics or velvet) or fabrics that slip easily (such as
vinyl, leather, or synthetic leather).
Note
• Thread the needle manually when using the
walking foot, or only attach the walking foot
after threading the needle using the
"Automatic Threading" button.
• When sewing with the walking foot, sew at
medium to low speeds.
Memo
• The walking foot can only be used with
straight or zigzag stitch patterns. Reverse
stitches cannot be sewn with the walking
foot. Only select straight or zigzag stitch pat-
terns with reinforcement stitches. (see page
74.)
a
Follow the steps in "Removing the Presser
Foot" on the previous page.
b
Loosen the screw of the presser foot holder
to remove the presser foot holder.
66
to unlock all keys and
c
Set the operation lever of the walking foot
so that the needle clamp screw is set
between the fork. Position the shank of the
walking foot on the presser foot bar.
a Operation lever
b Needle clamp screw
c Fork
d Walking foot shank
e Presser foot bar
d
Lower the presser foot lever. Insert the
screw, and tighten the screw securely with
the screwdriver.
CAUTION
• Use the included screwdriver to tighten the
screw securely. If the screw is loose, the
needle may strike the presser foot and cause
injury.
• Be sure to rotate the handwheel toward you
(counterclockwise) to check that the needle
does not strike the presser foot. If the needle
strikes the presser foot, injury may result.

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(