Download  Print this page

Brother Quattro 2 6700D Operation Manual Page 323

Embroidery and sewing machine.
Hide thumbs

Advertisement

h
Press
to unlock all keys and
buttons.
i
Lower the presser foot.
j
While holding both the upper thread and
the bobbin thread, sew a section of the
pattern.
k
Stop the machine, and then tie the upper
thread and the bobbin thread together to
secure the threads.
l
Start sewing again to finish the pattern.
m
Raise the needle and presser foot, remove
the embroidery frame, and then cut the
upper thread and the bobbin thread.
When cutting the threads, be sure to leave an
adequate length of thread so they can be
properly secured.
CREATING BOBBIN WORK (EMBROIDERY)
n
Using a hand sewing needle such as a
ribbon embroidering needle, pull the
bobbin thread to the top (wrong side) of the
fabric, and then tie the upper thread and
the bobbin thread together.
Memo
• If there is a gap between the start point and
end point of the pattern, cut the threads,
remove the fabric from the machine, and
then use a ribbon embroidering needle to
hand sew stitches to connect the starting
and ending points.
o
Remove the fabric from the embroidery
frame, and check the finished embroidery.
a Right side of fabric
p
If the desired results could not be achieved,
adjust the tension of the bobbin thread and
of the upper thread, and then try sewing the
pattern again.
For more details, refer to "ADJUSTING THE THREAD
TENSION" on page 322.
Memo
• Check bobbin after each bobbin work
embroidery pattern is sewn to make sure
there is adequate bobbin thread for the next
pattern.
b Wrong side of fabric
7
321

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(