Creating Bobbin Work (Embroidery); Selecting The Pattern - Brother VM5200 Operation Manual

CREATING BOBBIN WORK (EMBROIDERY)

CREATING BOBBIN WORK (EMBROIDERY)

Selecting the Pattern

Note
• Prepare the machine for bobbin work as
described in "PREPARING FOR BOBBIN
WORK" on page A-3.
a
Attach the embroidery foot and the
embroidery unit.
b
Install a bobbin wound with an adequate
amount of thread for pattern.
Note
• For an estimated length of bobbin thread
required for each pattern, refer to the
"Quick Reference Guide" included with the
machine. Be sure to use a bobbin wound
with enough thread. If the bobbin runs out
of thread while sewing, the embroidery
cannot be completed.
• Depending on the thread thickness, it may
not be possible to wind the bobbin with the
necessary length of thread. In this case, try
winding the bobbin again, or use a lighter
weight thread.
c
Pull up the bobbin thread above the needle
plate.
d
Turn on the machine.
e
Press .
 The carriage will move to the initialization position.
A-12
f
To select a bobbin work embroidery
pattern, press
Note
• Embroidery patterns for bobbin work "B"
cannot be used in the "Embroidery Edit"
screen (
g
Press , then select one of the bobbin
work embroidery patterns.
Embroidery patterns for bobbin work appear with
the letter "B" in the lower-left corner of the key.
a
a "B" mark
 Regardless of the setting that had been selected, the
automatic thread cutting function is turned off.
 When a bobbin work embroidery pattern is selected
the embroidery sewing speed can only be adjusted
from 100 spm to a maximum of 350 spm.
Note
• The beginning and end of stitching are
specified for bobbin work patterns. They
cannot be used for normal embroidering.
• Recommended default setting for bobbin
work embroidery is 100 spm.
(Embroidery).
).