Download  Print this page

Using The Foot Controller - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

f
Adjust the sewing speed with the speed
control slide.
*
You can use this slide to adjust sewing speed during
sewing.
a Slow
b Fast
g
Press the "Start/Stop" button to start
sewing.
*
Guide the fabric lightly by hand.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the "Start/
Stop" button.
h
Press the "Start/Stop" button again to stop
sewing.
i
Press the "Thread Cutter" button to trim
the upper and lower threads.
→ The needle will return to the up position
automatically.
CAUTION
• Do not press the "Thread Cutter" button after
the threads have been cut. Doing so could
tangle the thread or break the needle and
damage the machine.
• Do not press the "Thread Cutter" button when
there is no fabric set in the machine or during
machine operation. The thread may tangle,
possibly resulting in damage.
Note
• When cutting thread thicker than #30, nylon
monofilament thread, or other decorative
threads, use the thread cutter on the side of
the machine.
j
When the needle has stopped moving, raise
the presser foot and remove the fabric.
Memo
• This machine is equipped with a bobbin
thread sensor that warns you when the bob-
bin thread is almost empty. When the bobbin
thread is nearly empty, the machine auto-
matically stops. However, if the "Start/Stop"
button is pressed, a few stitches can be
sewn. When the warning displays, re-thread
the machine immediately.

■ Using the Foot Controller

You can also use the foot controller to start and stop
sewing.
CAUTION
• Do not allow fabric pieces and dust to collect
in the foot controller. Doing so could cause a
fire or an electric shock.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the "Start/
Stop" button.
• The foot controller cannot be used when
embroidering.
• The foot controller can be used for sewing
utility and decorative stitches when the
embroidery unit is attached.
SEWING
2
73

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(