Before Embroidering; Embroidery Step By Step - Brother Quattro 2 6700D Operation Manual

BEFORE EMBROIDERING

BEFORE EMBROIDERING

Embroidery Step by Step

Follow the steps below to prepare the machine for embroidery.
Step #
1 Presser foot attachment
2 Checking the needle
3 Embroidery unit attachment
4 Bobbin thread setup
5 Fabric preparation
6 Pattern selection
7 Embroidery frame attachment
8 Checking the layout
9 Embroidery thread setup
* It is recommended that a 90/14 needle should be used when embroidering on heavy weight fabrics or stabilizing products (for example;
denim, puffy foam, etc.). Ball point needle (golden colored) 90/14 is not recommended for embroidery.
186
Step 3
Step 1, 2
Step 7
Aim
Attach embroidery foot "W".
Use needle 75/11 for embroidery. *
Attach the embroidery unit.
For the bobbin thread, wind embroidery bobbin thread and set it in place.
Attach a stabilizer material to the fabric, and hoop it in the embroidery frame.
Turn the main power to ON, and select an embroidery pattern.
Attach the embroidery frame to the embroidery unit.
Check and adjust the size and position of the embroidery.
Set up embroidery thread according to the pattern.
Step 9
Step 4
Step 5
Action
Step 6, 8
Page
187
69
188
48
200
190
206
208
57