Moving the Pattern
For details on moving the pattern, refer to "Moving
the Pattern" on page 240.
Rotating the Pattern
For details on rotating the pattern, refer to
"Rotating the Pattern" on page 242.
Changing the Size of the Pattern
For details on changing the size of the pattern,
refer to "Changing the Size of the Pattern" on
Changing the Pattern Size While
Maintaining the Desired Thread
Density (Stitch Recalculator)
In the embroidery edit screen, the size of the
pattern can be changed while the desired thread
density is maintained.
With this function, the pattern will be enlarged or
reduced at a larger ratio than with normal pattern
• Be sure to sew trial embroidery using same
fabric and threads as project in order to
check the sewing results.
Select the pattern to be resized, and then
• This function cannot be used with alphabet
character patterns, frame patterns or border
patterns. However, a border pattern can be
edited after this function has been used.
• Patterns with a large number of stitches
(about 100,001 or more) cannot be resized
while maintaining a desired thread density.
The maximum limit for the number of
stitches differs depending on the data size of
• If this function is used, thread density is
maintained while the pattern is enlarged/
reduced. However, the needle drop point
pattern is not entirely maintained. Use the
normal resizing mode
on the results of trial embroidering.
to enter Stitch Recalculator
• Stitch Recalculator cannot be used if the key