Download  Print this page

Error Messages - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

ERROR MESSAGES

ERROR MESSAGES
If the machine is not properly set and the "Start/Stop" button or the "Reverse/Reinforcement Stitch" button
is pressed, or if the operation procedure is incorrect, the machine does not start. An alarm sounds and an
error message is displayed on the LCD. If an error message displays, follow the instructions in the
message.
Below is an explanation of error messages. Refer to these when necessary (if you press
operation correctly while the error message is displayed, the message disappears).
• Be sure to rethread the machine. If you press the "Start/Stop" button without rethreading the machine,
the thread tension may be wrong or the needle may break and cause injury.
348
CAUTION
This message is displayed
when the motor locks due to
tangled thread or for other
reasons related to thread
delivery.
This message is displayed
when the embroidery unit is
initializing.
This message is displayed
when you try to sew with a
stitch other than a middle
needle position stitch while
the single-hole needle plate is
installed.
This message is displayed
when the needle plate is
removed with the machine on
or when the machine is
turned on and embroidery or
embroidery edit mode is
selected (see page 54).
This message is displayed
when the machine needs to
be maintained. (see page
341)
or do the
This message is displayed
when the needle plate cover
is not attached.
This message is displayed
when you try to combine
more than 71 patterns.
This message is displayed
when the buttonhole lever is
up, a buttonhole stitch is
selected, and the "Start/
Stop" button or "Reverse/
Reinforcement Stitch" button
is pushed.
This message is displayed
when the speed control lever
is set to control the zigzag
stitch width, and the "Start/
Stop" button is pushed. Use
the foot controller to operate
the machine.

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(