Download  Print this page

Dart Seam; Gathering - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

Table of Contents

Dart Seam

a
Select
and attach presser foot "J".
b
Sew a reverse stitch at the beginning of the
dart and then sew from the wide end to the
other end without stretching the fabric.
*
If automatic reinforcement stitching is preset, a
reinforcement stitch will automatically be sewn at
the beginning of sewing.
a Basting
c
Cut the thread at the end leaving 50 mm
(approx. 1-15/16 inches), and then tie both
ends together.
*
Do not sew a reverse stitch at the end.
d
Insert the ends of the thread into the dart
with a hand sewing needle.
e
Iron the dart to one side so that it is flat.

Gathering

Use on waists of skirts, sleeves of shirts, etc.
a
Select a straight stitch and attach presser
foot "J".
b
Set the stitch length to 4.0 mm (approx.
3/16 inch) and the thread tension to
approximately 2.0 (weaker tension).
*
If you press
and then
automatically to 4.0 mm (approx. 3/16 inch) and the
thread tension will be automatically set to 2.0.
SEWING THE STITCHES
after pressing
, the stitch length will be set
3
99

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(