Download  Print this page

Using The Automatic Thread Cutting Function (end Color Trim); Bobbin Thread Is Too Loose; Bobbin Thread Is Too Tight - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

■ Bobbin Thread is Too Loose

Bobbin thread appears slightly on the right side of
fabric.
a Right side
b Wrong side
If this occurs, turn the slotted screw (-) clockwise,
being careful not to over-tighten the screw,
approximately 30-45 degrees to increase bobbin
tension.

■ Bobbin Thread is Too Tight

Upper thread on the right side of fabric seems to be
lifting/looping and bobbin thread is not seen on the
wrong side of fabric.
a Right side
b Wrong side
If this occurs, turn the slotted screw (-)
counterclockwise, being careful not to over-loosen
the screw, approximately 30-45 degrees to decrease
bobbin tension.
CAUTION
• When adjusting the alternate bobbin case, be
sure to remove the bobbin from the alternate
bobbin case.
• DO NOT adjust the position of the phillips (+)
screw on the alternate bobbin case as this may
result in damage to the bobbin case, rendering
it unusable.
• If the slotted screw (-) is difficult to turn, do
not use force. Turning the screw too much or
providing force in either (rotational) direction
may cause damage to the bobbin case. Should
damage occur, the bobbin case may not
maintain proper tension.
MAKING EMBROIDERY ADJUSTMENTS
Using the Automatic Thread
Cutting Function
(END COLOR TRIM)
The automatic thread cutting function
cut the thread at the end of sewing each color.
This function is initially turned on. To turn this
function off, press
function can be turned on or off during
embroidering.
*
This setting returns to its default
when the machine is turned off.
a
Press
.
b
Press
to turn off the automatic thread
cutting function.
→ The key will display as
*
When one color thread is sewn, the machine will
stop without cutting the thread.
will
key and then
. This
5
235

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

   Related Content for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(