Default Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 64-9
Select the switch whose port rate limit you want to change.
Step 3
Enter the desired port rate limit in the Percent column.
Step 4
Click the Apply Changes icon to save your changes.
Step 5
Default Settings
Table 64-3
.
Table 64-3
Parameters
FCC protocol
QoS control traffic
QoS data traffic
Zone-based QoS priority
Rate limit
Cisco MDS 9000 Family Fabric Manager Configuration Guide
64-12
Rate Limits for Switch Interfaces
lists the default settings for FCC, QoS, and rate limiting features.
Default FCC, QoS, and Rate Limiting Settings
Chapter 64 Configuring Fabric Congestion Control and QoS
Default
Disabled.
Enabled.
Disabled.
Low.
100%
OL-17256-03, Cisco MDS NX-OS Release 4.x