Adjusting For Daylight Savings Time; Locating Other Switches - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Locating Other Switches

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 66-9
Click Close to close the dialog box.
Step 6

Adjusting for Daylight Savings Time

Starting in 2007, daylight savings time in the United States starts on the second Sunday in March and
Note
ends on the first Sunday in November.
You can use the Run CLI Commands feature in Fabric Manager to adjust the time change configuration
in your switches. Enter the following commands in the Command(s) text box.
config t
no clock summer-time
clock summer-time daylight_timezone_name 2 Sunday March 02:00 1 Sunday November 02:00 60
exit
Locating Other Switches
The Locate Switches option uses SNMPv2 and discovers devices responding to SNMP requests with the
read-only community string public. You can use this feature if:
•
•
Cisco MDS 9000 Family Fabric Manager Configuration Guide
66-12
Run CLI Commands Status
You have third-party switches that do not implement the FC-GS3 FCS standard that provides
management IP addresses.
You want to locate other Cisco MDS 9000 switches in the subnet but are not physically connected
to the fabric (and therefore cannot be found via neighbors).
Chapter 66 Troubleshooting Your Fabric
OL-17256-03, Cisco MDS NX-OS Release 4.x