Configuring Contact Information - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring Contact Information

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configure destination profiles.
Step 2
Associate one or more alert groups to each profile as required by your network. Customize the alert
Step 3
groups, if desired.
Configure e-mail options.
Step 4
Enable or disable Call Home.
Step 5
Test Call Home messages.
Step 6
Configuring Contact Information
Each switch must include e-mail, phone, and street address information. You can optionally include the
contract ID, customer ID, site ID, and switch priority information.
Switch priority is specific to each switch in the fabric. This priority is used by the operations personnel
Note
or TAC support personnel to decide which Call Home message they should respond to first. You can
prioritize Call Home alerts of the same severity from each switch.
To assign the contact information using Fabric Manager, follow these steps:
In the Fabric Manager Physical Attributes pane, expand Switches, expand Events, and select Call
Step 1
Home.
You see the Call Home tabs in the Information pane (see
Figure 62-1
In Device Manager, click Admin > Events > Call Home. See
Step 2
Cisco MDS 9000 Family Fabric Manager Configuration Guide
62-6
Call Home in Fabric Manager
Chapter 62
Figure 62-1).
Figure 62-2.
OL-17256-03, Cisco MDS NX-OS Release 4.x
Configuring Call Home