Default Span Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 60 Monitoring Network Traffic Using SPAN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 60-10
SD Port
fc2/1
To use this setup, the analyzer should have the capability of distinguishing ingress and egress traffic for
all captured frames.

Default SPAN Settings

Table 60-1
Table 60-1
Parameters
SPAN session
If filters are not specified
Encapsulation
SD port
OL-17256-03, Cisco MDS NX-OS Release 4.x
Fibre Channel Analyzer Using a Single SD Port
Bidirectional source in session 1 - SD port fc2/1
Cisco
MDS 9000
switch
fc1/1
TX
Dropped*
TX
TX
1
FC Analyzer
lists the default settings for SPAN parameters.
Default SPAN Configuration Parameters
Default
Active.
SPAN traffic includes traffic through a specific interface from all active
VSANs.
Disabled.
Output frame format is Fibre Channel.
TX
RX
* The egress (TX) traffic coming out from
the analyzer ports will be dropped.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Default SPAN Settings
Storage
device
60-13