Transitioning From Ipv4 To Ipv6; Default Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 54 Configuring IPv6 for Gigabit Ethernet Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Transitioning from IPv4 to IPv6

Cisco MDS NX-OS does not support any transitioning mechanisms from IPv4 to IPv6. However, you
can use the transitioning schemes in the Cisco router products for this purpose. For information on
configuring Cisco routers to transition your network, refer to the
chapter in the

Default Settings

Table 54-2
Table 54-2
Parameters
IPv6 processing
Duplicate address detection
attempts
Reachability time
Retransmission time
IPv6-ACLs
OL-17256-03, Cisco MDS NX-OS Release 4.x
Cisco IOS IPv6 Configuration
lists the default settings for IPv6 parameters.
Default IPv6 Parameters
Default
Disabled.
0 (neighbor discovery disabled).
1000 milliseconds.
30000 milliseconds.
None.
Implementing Tunneling for IPv6
Guide.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Transitioning from IPv4 to IPv6
54-15