Configuring The Cisco Telepresence Management Server; Installation Precautions And Hardware Compliances - Cisco TELEPRESENCE MANAGEMENT SUITE Installation And Getting Started Manual

Configuring the Cisco TelePresence
Management Server
The Cisco TelePresence Management Server Appliance is delivered with Cisco TelePresence
Management Suite (Cisco TMS) pre-installed so that you can deploy Cisco TMS without having to buy,
configure, or install your own server and operating system. The Cisco TelePresence Management
Server Appliance is intended for small to medium sized networks (up to 100 managed systems).
Note: If the Cisco TMS Agent is to be utilized on the Cisco TelePresence Management Server, Cisco
TelePresence recommends a limit of 5000 users in the Provisioning Directory.
This section has three topics
Initial setup and configuration of the
Operation, maintenance, and upgrading the
TMS software installation/upgrades on the Cisco TelePresence Management Server
For information regarding the configuration of the Cisco TelePresence Management Server Appliance,
see the Cisco TMS Administrator
Initial setup and configuration of the Cisco TelePresence Management Server

Installation precautions and hardware compliances

Safety precautions:
Never install communication wiring during a lightning storm.
Never install jacks for communication cables in wet locations unless the jack is specifically
designed for wet locations.
Never touch uninstalled communication wires or terminals unless the communication line has
been disconnected at the network interface.
Use caution when installing or modifying communication lines.
Avoid using communication equipment (other than a cordless type) during an electrical storm.
There may be a remote risk of electrical shock from lightning.
Do not use the communication equipment to report a gas leak in the vicinity of the leak.
Always connect the product to an earthed socket outlet.
The socket outlet must be installed near to the equipment and be easily accessible.
Switch the power OFF before installing cables.
This product complies with the following directives:
LVD 73/23/EC, EMC 89/366/EEC, R&TTE 99/5/EEC,
Directive 73/23/EEC (Low Voltage Directive)
Standard EN 60950-1
Directive 89/336/EEC (EMC Directive)
Standard EN 55022, Class A
Standard EN 55024
Standard EN 61000-3-2/-3-3
Approved according to UL 60950-1 and CAN/CSA C22.2 No. 60950-1-03
Cisco TelePresence Management Suite Installation and Getting Started Guide

Configuring the Cisco TelePresence Management Server

Guide.
Page 29 of 70