Starting Gui Server And Device Server Processes Manually; Stopping Server Processes; Configuring Server Options - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Starting GUI Server and Device Server Processes Manually

Stopping Server Processes

Configuring Server Options

Copyright © 2010, Juniper Networks, Inc.
If you have not installed the HA Server process, you can manually start the GUI Server
and Device Server processes.
To start the GUI Server manually, enter the following command:
/usr/netscreen/GuiSvr/bin/guiSvr.sh start
To start the Device Server manually, enter the following command:
/usr/netscreen/DevSvr/bin/devSvr.sh start
NSM server processes always run with nsm user permissions, even if you have root user
permissions when you start them.
You can manually stop each server process as follows.
To stop the GUI Server manually, enter the following command:
/usr/netscreen/GuiSvr/bin/guiSvr.sh stop
To stop the Device Server manually, enter the following command:
/usr/netscreen/DevSvr/bin/devSvr.sh stop
To stop the HA Server process manually, enter the following command:
/usr/netscreen/HaSvr/bin/haSvr.sh stop
NOTE: To prevent the server from rebooting in a HA configuration that uses
shared disks, you must ensure that none of the shared files are in use before
stopping the HaSvr process. If these files are in use (for example, by a vi or
tail command), then the configured file system unmount command will fail,
causing the server to reboot.
The following procedures are provided for your reference:
Changing the Management System IP Address on page 174
Changing the Device Server IP Address on page 174
Changing the GUI Server IP Address on page 175
Configuring Disk Space Management on the Device Server on page 175
Configuring Disk Space Management on the GUI Server on page 176
Configuring Connection Timing on page 177
Setting Core File Naming on Solaris on page 177
Chapter 8: Maintaining NSM
173