Copier Error Messages; Image Data Setting Error Messages - Ricoh 3245e Operating Instructions Manual

Appendix

Copier Error Messages

This section describes possible causes of and actions to take for error messages
displayed on the machine's operation panel. Error messages are classified into
three groups: the image data settings, the copier and the Network Delivery scan-
ner.
Note
If an error message that is not described here appears, turn the power off and
on. If this does not clear the error message, take a note of the contents and
number of the error message and contact your sales or service representative.
Reference
If an error message appears on the display of the client computer starting a
scan, see P.39 "Type 270 TWAIN Driver Ver.2 Error Messages".
5

Image Data Setting Error Messages

Cannot detect original size. Check wheth-
er original is placed and select the proper
size.
Invalid data size. Check the scanning res-
olution.
Memory full. Cannot continue, send the
existing scanned data or delete, reset and
repeat the process.
Memory full. Cannot scan. Scanning has
stopped the scanned data has been delet-
ed.
36
• Place the original again.
• Set the original size to be scanned.
• Reset the original size to be scanned.
• Lower the resolution value.
• Add the optional memory module.
• Reset the original size to be scanned.
• Lower the resolution value.
• Add the optional memory module.
Note
This message appears when the second
or later pages of the originals cannot be
scanned. If you want to send the
scanned pages (up to the previous
page) only, press [Send]. This proce-
dure must be completed within about
15 minutes after the error occurs. If you
press [Delete], all the stored data is de-
leted and no data is sent. Scan the re-
maining pages after the memory
capacity is back to normal.
• Press [Exit] and delete the scanned da-
ta.
• Add the optional memory module.