Standby Display; Communication Display - Ricoh 3245e Operating Instructions Manual

Chapter1 Page 11 Thursday, January 27, 2000 1:53 PM

Standby Display

While the machine is in standby mode (immediately after it is turned on or after
the {Clear Modes/Energy Saver} key is pressed), the following display is shown.
Memory Transmission
Immediate Transmission
Note
To return the machine to standby mode, do one of the following:
• If you have set an original and are in the sending process, remove the orig-
inal.
• If you have not set an original and are in the sending process, press the
{Clear Modes/Energy Saver} key.
• If you are in User Tools mode, press the {User Tools/Counter} key.

Communication Display

While the machine is communicating the status is displayed.
Display during Memory Transmission or Memory Reception:
Note
Even when the machine is sending or receiving a fax message from/into
memory, you can still scan the next original into memory.
cess"
Immediate Transmission:
Reading the Display
1
P.13 "Dual Ac-
11