Changing The Line Type; Auto Identification - Ricoh 3245e Operating Instructions Manual

Chapter2 Page 43 Thursday, January 27, 2000 1:54 PM

Changing the Line Type

The optional ISDN Unit or optional extra G3 Interface Unit is required.
When the optional ISDN Unit are in-
stalled, you can connect to up to a
maximum of 2 lines.
This machine comes with a single an-
alog (PSTN) line connection for G3
communication as standard.
Press the {F4} key to change the line
type.
Note
When you install the optional
ISDN Unit, you can select G3 or G4
as the home position.
"Changing the User Parameters"
When sending a fax, you can select
the line type if dialing with the
number keys or Chain Dial.
When only the optional ISDN Unit is
installed
A
Press the { { { { F4} } } } key to switch be-
tween G3 and G4.
Note
When the {F4} key is lit, G4 is
selected.
G3 is selected after power up or
when the machine is reset.
Whether the PSTN or ISDN line
is used depends on the settings
explained later in this section.
Limitation
If you select G4 mode, JBIG
compression is not available.
- - Which line is used for G3 - -
P.227
transmissions?
ISDN lines can be used for G3 com-
munication as well as G4 communica-
tions, however, this machine is set by
default to use the PSTN line for G3
transmissions.
Note
When you use G3 with ISDN, you
can set the subaddress.
If you wish to use the digital (IS-
DN) line for G3 transmissions,
please contact your service repre-
sentative.

- Auto Identification

-
- -
This feature is used when G4 is select-
ed. The machine first tries a G4 com-
munication and if it cannot connect
because the receiver is not a G4 termi-
nal, it automatically switches to G3
and redials.
Changing the Line Type
43
2