Automatic Redial - Ricoh 3245e Operating Instructions Manual

Chapter2 Page 29 Thursday, January 27, 2000 1:54 PM
- Sending a Fax Message - - -
Immediately
To send a fax message immediately,
use Immediate Transmission. If you
have just set up an original for broad-
casting, Immediate Transmission will
interrupt the current communication.
If there are files queued in addition to
the file being currently sent, your
original is not be sent until the
queued files have been sent.

- Automatic Redial

- - -
If a fax message could not be trans-
mitted because the line was busy or
an error occurred during transmis-
sion, redialing is done 4 times at 5
minutes intervals (these figures vary
according to which country you are
in).
If redialing fails after four redials, the
machine cancels the transmission and
prints the Transmission Result Report
or Communication Failure Report.
P.30 "Transmission
(Memory Transmission)", P.31 "Com-
munication Failure
"When Power is Turned off or Fails"
- Broadcasting Sequence - - -
If you dial several destinations for the
same message (Broadcasting) the
messages are sent in the order in
which they were dialed. If the fax
message could not be transmitted, the
machine redials that destination after
the last destination specified for
Broadcasting. For example, if you
specify four destinations A through D
for broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
When the optional ISDN Unit or op-
tional extra G3 Interface Unit is in-
stalled,
simultaneously on multiple lines.
- - Checking the Transmission - -
Progress
To check which destinations the fax
message has been sent to so far, print
the TX file list.
of Files in Memory (Print TX File List)"
- If Memory Runs Out While -
- -
Storing an Original
If you run out of memory while stor-
ing an original (free space reaches
0%),
Press [Exit] to transmit the stored pag-
es only.
Result Report
Report", P.134
Note
By default, successfully scanned
pages are sent. If you wish to
change this setting, please contact
your service representative.
Memory Transmission
you can broadcast
P.117 "Printing a List
is displayed.
"Memory full"
2
29