Using Windows Nt 4.0 - Ricoh 3245e Operating Instructions Manual

D
Read the message on the screen
carefully. If you agree, click [Yes].
Uninstallation starts.
E
When [Uninstall successfully] is dis-
played below the dialog box,
click [OK].
The dialog box closes.

Using Windows NT 4.0

Preparation
Before installation, confirm that
the computer you are using is con-
figured to use the TCP/IP proto-
col, by selecting [Protocols] in
[Network] from [Control Panel].
Note
To install the Type 270 TWAIN
Driver Ver.2, you must be logged
on as a member of the Administra-
tors group.
Installing
A
Close all the applications that are
currently running.
B
Insert the CD-ROM into the CD-
ROM drive.
A setup program starts automati-
cally and the [welcome] dialog box
appears.
Reference
If the setup program does not
start automatically, see P.24
"Starting the Setup Program".
C
Read the message on the screen
carefully. If you agree, click
[Next].
[Software License Agreement] ap-
pears.
Installing/Uninstalling Type 270 TWAIN Driver Ver.2
D
Read the message on the screen
carefully. If you agree, click [Yes].
[Select Program Folder] appears.
E
Read the message on the screen
carefully. If you agree, click
[Next].
Usually, you do not need to
change the program folder.
Installation starts, and [Setup Com-
plete] is displayed when it is com-
pleted.
F
Confirm the message on the
screen, and then click [Finish].
Select [Yes, I want to restart my com-
puter now.].
Note
If the screen message asking if
you want to restart the compu-
ter does not appear in step F,
click [Finish].
When Finishing Installation
After installation, "Type 270 TWAIN
Driver Ver.2", "Help Files" and "Re-
adme.txt" are registered.
Help Files
"Help Files" is a help system that
contains information about the op-
erational process to scan an image
and configuring the image data
settings using Type 270 TWAIN
Driver Ver.2.
Readme.txt
"Readme.txt" contains informa-
tion about using Type 270 TWAIN
Driver Ver.2. Be sure to read it be-
fore using them.
3
25