Ricoh 3245e Operating Instructions Manual page 532

Setting Up the Scanner
• If you press [OK] after selecting
"6. Network Boot" in step D, the
following
"*"(asterisk) is displayed with
the current settings. When this
occurs, you can change the set-
ting by selecting the items.
2
F
Start settings.
• When entering numerical val-
ues, use the number keys. If you
press {#} after entering numeri-
cal values, you can continue to
the next column. < or > can be
also available to change the in-
put position.
• When selecting items, press [ ]
or [ ] to navigate through the
items to be configured on the
panel display.
Note
For more information about the
setting items, see P.13 "Network
Setting Items".
To cancel the current settings,
press [Cancel]. The settings re-
turn to their previous values,
and the previous screen ap-
pears.
G
Press [OK].
Changed values are saved and the
message displayed in step D ap-
pears.
Note
From this screen, you can also
configure other network set-
tings.
12
message appears.
H
Press [PrevMenu].
The message displayed in step C
appears.
Note
From this screen, you can also
make the image data settings
and the scanner settings.
I
Press [PrevMenu].
The message displayed in step A
appears.
J
Press [Exit].
The changed settings are saved,
and the message before the set-
tings were made appears.
Important
After pressing [Exit], do not turn
off the machine until the main
menu is displayed, or the set-
tings will not be applied.
Note
The changed settings cannot be
saved until you press [Exit].
These settings also cannot be
saved if the power is turned off
before [Exit] is pressed.
If you press {User Tools/Counter}
while navigating the message
screens, changed settings will
not be saved.