Ricoh 3245e Operating Instructions Manual page 287

Chapter2 Page 35 Thursday, January 27, 2000 1:54 PM
Reference
P.45 "Dialing"
P.43 "Changing the Line Type"
E
Press the { { { { Start} } } } key.
The machine calls the destination.
While it is dialing, the number or
name which is programmed as the
RTI or CSI in the machine of the
other party is shown on the dis-
play. When connected, the ma-
chine starts scanning the original.
Reference
P.187 "RTI/TTI"
After transmission, the machine
will return to standby mode.
Sending Originals from the
Exposure Glass
A Set the first page face down on
the exposure glass.
B Dial.
C Press the { { { { Start} } } } key.
Immediate Transmission
The machine starts scanning the
original.
D Set the next original on the ex-
posure glass within 10 seconds
after the machine has finished
scanning the first original.
Note
Repeat steps C to D for all
originals.
E Set the last original then press
# ].
# #
[#
F Press the { { { { Start} } } } key.
The machine starts to call the
destination.
- If the Connection Could Not Be -
- -
Made
The following display appears if the
fax could not be sent:
Do one of the following:
• Press [Cancel] and try again.
• Press [Memory TX] to have the ma-
chine scan in the document and
then automatically redial the num-
ber.
- ECM (Error Correction Mode) -
- -
This feature automatically sends data
that was not transmitted successfully
again using a technique called ECM,
an internationally recognized proto-
col (requires that the destination ma-
chine has the same feature).
2
35