Table of Contents
Advertisement
Chapter3 Page 72 Thursday, January 27, 2000 1:55 PM
Receiving a Fax Message
Page Separation and Length
Reduction
When the size of a received message
is longer than the paper loaded in the
machine, each page of the message
can be split and printed on several
sheets, or reduced and printed on a
single sheet. For example, this feature
splits the received message if the ex-
3
cess length is about 0.79" or more,
and reduces it if the excess length is
within about 0.79". When a message
is split, the split mark (*) is inserted at
the split position and about 0.39" of
the split area is duplicated on the top
of the second sheet.
ABC
(Document)
Note
Your service representative can
customize this feature with the fol-
lowing settings. Bracketed values
are defaults.
• Reduction (on)
• Print split mark (on)
• Overprinting (on)
• Overprinting length (0.39")
• Guideline for split (when mes-
sage is 0.79" longer than paper)
You can adjust the overprinting
length and length of reduction
within the following ranges:
72
• Guideline for split: 0.2" 6.1"
(0.2" steps)
• Overprinting
0.39", 0.6"
Reverse Order Printing
Normally, received pages are printed
and stacked on the tray in the order
they are received. If you turn this fea-
ture on, the machine will start print-
ing the message from the last page
received.
your machine
Note
By default, this feature is turned
off. Switch it on with the Initial Set-
ND1X01E1
up RX.
P.174 "Initial Setup RX"
When this feature is on, the first
page will be printed last.
This feature uses Memory Recep-
tion.
Page Reduction
If you have switched this feature on
and you receive a message that is
longer than the paper in the cassette,
usually the machine prints it on two
pages. If you turn this feature on, the
machine reduces the width and
length of the received image so that it
will fit on one page. If A4L paper
size is loaded and a message of B4 L
size is received, the machine will re-
length:
0.16",
Print
ND1X01E2
Advertisement
Chapters
Table of Contents
Troubleshooting
