Registering An Irregular Area - Ricoh 3245e Operating Instructions Manual

Chapter7 Page 166 Thursday, January 27, 2000 1:57 PM
Facsimile User Tools
E
Enter the "Auto Doc. orig." code
with the number keys.
Note
If "Reg. Auto Doc." is not
shown, press [ Prev.] or [ Next].
F
Enter the number of the Auto
Document you wish to print out
with the number keys.
G
Press the { { { { Start} } } } key.
7
When printing is completed, the
display shown in step E appears
again.
Note
If you press [Cancel] before
printing starts, the printing
stops and the display shown in
step E appears again.
H
Press the { { { { User Tools/Counter} } } } key.

Registering An Irregular Area

When you select Irregular Area to
scan a non-standard size original, two
custom sizes of original are available
(Area 1 and Area 2). Use this function
to register these custom sizes in ad-
vance.
166
To change an existing Irregular Scan
size, just use the following procedure
to overwrite it.
Important
When registering or changing an
original size, we recommend that
you make a memo of the new size.
Limitation
For the vertical length (width), se-
1
lect "Auto", "8 / inch", "11 inch",
2
"8.3 inch (A4L)",
(B4L)", or "11.7inch (A3L)".
For the horizontal length, specify
from 128 to 432mm or from 5.5 to
17 inches.
A
Make sure that the machine is in
Facsimile mode and the standby
display is shown.
Note
If the standby display is not
shown, press the {Fax} key.
B
Press the { { { { User Tools/Counter} } } } key.
C
Enter the code for "Fax" with the
number keys.
The Facsimile User Tool main
menu appears.
"10.1inch