Ricoh 3245e Operating Instructions Manual page 269

Chapter1 Page 17 Thursday, January 27, 2000 1:53 PM
Document Feeder (ADF)
Horizontal size
Maximum Scanning area
(297x432mm)
A4 A3
Limitation
There may be a difference in the size of the image when it is printed at the des-
tination.
If you set an original larger than 11" 17"/A3 on the exposure glass, only the
11" 17"/A3 area is scanned.
Note
Even if an original is correctly placed on the exposure glass or in the Docu-
ment Feeder (ADF), a margin of 3mm around each edge of the original may
not be sent.
If the receiver uses paper narrower than the original, the image will be re-
duced to fit the paper width.
The machine detects paper sizes in the following ways.
• When you set an original in the Document Feeder (ADF), an original wider
than about 10.4" (263mm) is scanned as 11" 17" size.
An original narrower than about 9.1" (230mm) will be sent as 8
1
8 / " 14" size.
2
Originals up to 17" (432mm) in length can be scanned.
• See the table below for the sizes the machine can detect when you set an
original on the exposure glass. Because the machine scans in non-standard
size documents as one of the standard sizes, parts of the image may be
truncated depending on the length of the document. For how to set non-
standard size documents,
(Irregular Scan Area)".
9.6"
Width
9.6" 10.6"
10.6"
CP02AEE1
P.106 "Auto Reduction"
P.92 "Choosing the Area to be Scanned Yourself
Length
9.8" 9.8" 10.8"
not detected 8
1
/ " 11"L
2
1 11" 17"L
11" 8 / "K
2
11" 17"L
1
11" 8 / "K
2
Acceptable Types of Originals
1
/ " 11" or
2
10.8" 12.4" 12.4"
1 1
8 / " 11"L 8 / " 14"L
2 2
11" 17"L 11" 17"L
11" 17"L 11" 17"L
1
17