Transfer Result Report; Id Reception (Closed Network); F Code (Sep) - Ricoh 3245e Operating Instructions Manual

Chapter3 Page 65 Thursday, January 27, 2000 1:55 PM
Reference
P.196 "Multistep Transfer"
- - Sending the Transfer Result - -
Report
This machine compares the own fax
number of the Requesting Party with
the Requesting Party's number pro-
grammed in a Quick Dial or Speed
Dial, and if the lower five digits of the
two numbers match, it sends the
Transfer Result report to the Request-
ing Party.
For example:
• Requesting Party's own dial num-
ber:
001813-11112222
• Transfer Station's Quick Dial:
213-111-2222

Transfer Result Report

This reports whether transmission to
the End Receivers was successful or
not.
Preparation
Register the own fax number in ad-
vance. P.43 "Changing the Line
Type"
When the Transfer Station has trans-
ferred the message to all End Receiv-
ers, it sends the Transfer Result
Report back to the Requesting Party.
The machine prints the report if it
cannot be sent back to the Requesting
Party. You must program the fax
number of the requesting party in a
Quick Dial or Speed Dial in the Trans-
Reception Functions
fer Station. P.137 "Registering Quick
Dials", P.152 "Registering Speed Dials"
Note
By default, a portion of the original
image is printed on this report.
You can turn this off with the User
Parameters. P.227 "Changing the
User Parameters"

ID Reception (Closed Network)

If you wish to limit reception of mes-
sages to those from machines of the
same make and with the same Polling
ID, contact your service representa-
tive to turn this feature on.

F Code (SEP)

Normally you can only use Polling
Reception to receive faxes from ma-
chines that have the Polling Recep-
tion feature of the same make.
However, if the other machine of an-
other make supports a polling recep-
tion, you can receive fax messages
from the other party using this meth-
od instead.
Preparation
You need to assign the F Code fea-
ture to a User Function key before-
hand. P.179 "Storing/Editing the
Contents of a User Function Key"
Limitation
You can only use this feature with
a G3 line (not with G4).
You cannot use Chain Dial with
this feature.
Note
The ID can be up to 20 digits long
and consist of digits.
3
65