Snmp Configuration Example - 3Com Switch 4500 26-Port Configuration Manual

Table 328 Disp
Operation
lay and Debug
Display the statistics information about
SNMP
SNMP packets
Display the engine ID of the active device
Operation
Display the group name, the security
mode, the states for all types of views,
and the storage mode of each group of
the Switch.
Display the names of all users in the group
user table
Display the current community name
Display the current MIB view
Display the contact character string of the
system
Display the location character string of the
system
Display the version character string of the
system
SNMP Configuration
Example
Command
display snmp-agent statistics
display snmp-agent { local-engineid
| remote-engineid }
Command
display snmp-agent group [
group-name ]
display snmp-agent usm-user [
engineid engineid ] [ group groupname
] [ username username ]
display snmp-agent community [ read
| write ]
display snmp-agent mib-view [
exclude | include | viewname
mib-view ]
display snmp-agent sys-info contact
display snmp-agent sys-info
location
display snmp-agent sys-info version
Networking Requirements
Network Management Station and the Switch are connected via the Ethernet. The
IP address of Network Management Station is 129.102.149.23 and that of the
VLAN interface on the Switch is 129.102.0.1. Perform the following
configurations on the Switch: set the community name and access authority,
administrator ID, contact and Switch location, and enable the Switch to send trap
packet.