COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 94

To change the administrator password
To change the administrator password, do as follows:
1. Log in as administrator.
2. Under Advanced, select Passwords.
3. Select Change administrator password.
4. Type in the Old password.
5. Type in the New password and retype it on the next line.
Note
6. Click Save.
At the next login the new password is required.
To log out as administrator
If you close the web interface, you are logged out automatically after 30 seconds. To
log out manually, click Log out administrator in the Advanced page or click [log out]
next to administrator in the Terminal status field.
4.13.2 To set up user permissions
You can allow or deny users access to certain functions and make these pages read-
only. This is useful if you want to protect the system against unintended changes.
Study this screen thoroughly and decide to which areas of the system you want to give
non-administrator users access. To set up the user permissions, do as follows:
1. Under Advanced, select User permissions.
2. Under Allow users to, select the settings you want to allow users to access.
3. Under Allow user accounts, select Service user account if you want to enable the
use of a service user account.
4. Click Save.
Only the settings with a check mark can be changed by the non-administrator user,
other settings can only be viewed.
98-148232-K
The password must be 5 to 15 characters long and cannot contain spaces.
Avoid special characters. Accepted characters: A through Z (upper-case
characters), a through z (lower-case characters) and 0 through 9 (numeric
characters).
Chapter 4: Configuration with web interface
Advanced settings
4-30