COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 163

Parameters
The table below summarizes the available parameters for the SMS remote commands.
Parameter Values
<apn_type> SIM default
Network
assigned
User defined
NA
<apn> <APN>
NA
CLR
<at_cmd> <at_cmd>
<category> 1
2
3
4
<cmd_op> 1
2
<dataset> GPS
USAGE
ALL
<get_set> 1
2
<imei> <14 digits>
<info_mode> 1
2
<interval> <integer>
NA
<PC/TE type> DHCP
STATIC
AWO
<name>
<IP addr>
ANY
98-148232-K
Meaning
Read the APN from the SIM card.
Use the APN assigned by the network.
Specify another APN to use.
Placeholder when no value is specified. The existing setting applies.
APN name, e.g. bgan.inmarsat.com.
Placeholder when no APN is specified. Note that any previously entered
APN is maintained.
No APN is used.
AT command, without prefix AT. For supported AT commands, see
ATCO commands on page B-10.
Delete only Read SMS messages.
Delete Read and Sent.
Delete All except Unread.
Delete All SMS messages.
Get WANMODE setting
Set WANMODE configuration
GPS position.
Cumulative call time and data usage.
GPS position plus call time and data usage.
Get parameters.
Set parameters.
IMEI of the EXPLORER 540, without dashes or check digit.
For GPS query: position data only. For other queries: use verbose mode
(with titles).
For GPS query: position data plus SMS usage. For other queries: use
terse mode (no titles).
The number of hours between the Terminal watchdog sessions (1-504).
Placeholder when no value is specified. The existing setting applies.
All TEs known via DHCP.
All TEs known via Terminal settings.
Always On, deactivate all PDP contexts including those established with
ACA.
Name of specific TE, as known by DHCP server.
IP Address of specific TE (or Global IP for DEACTIVATE).
Any/all TEs attached (DEACTIVATE: all except PDP context established
with ACA).
Appendix B: Command reference
SMS remote commands
B-5