COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 60

In this example. the terminal will look for a file named config.txt in the local
directory (/) in the terminal, and send the file to the directory ftpdirectory on the
FTP server named ftp.myftpserver.com. The user name ftp-username and
password ftp-password give access to the FTP server. The default APN is used
(APN info is left out).
3. You get a response command that the file was transferred successfully.
Example: _ISENDFILE: 0, Complete
Load configuration
To command the EXPLORER 540 to update its configuration, do as follows:
1. Place the configuration file on your FTP server.
2. To access the EXPLORER 540, use one of the following:
• a computer connected to the Internet, see Remote access with AT commands on
page 3-10, or
• equipment connected to a cellular network, see Remote access with SMS on
page 3-4.
Note that you need a password for both access methods. For AT commands, use
the AT_ICLCK command with the admin password, for SMS, use the remote SMS
password.
3. Send the command _IGETFILE to the EXPLORER 540 to download the
configuration file from the specified FTP server.
Leave out APN information if you are using default APN.
Example: AT_IGETFILE="ftpdirectory","config.txt","/",
In this example. the terminal will look for a file named config.txt in the directory
ftpdirectory on the FTP server named ftp.myftpserver.com and download the
file to the directory named / in the terminal. The user name ftp-username and
password ftp-password give access to the FTP server. The default APN is used
(APN info is left out).
4. You get a response command that the configuration file was successfully
downloaded from the ftp server to the terminal.
Example: _IGETFILE: 0, Complete
5. Use the command AT_IUPDCFG to upgrade the EXPLORER 540 configuration using
the file downloaded in step 3.
Example: AT_IUPDCFG=config.txt
This command will take the downloaded configuration file named config.txt and
use it to update the configuration of the EXPLORER 540.
Note
6. You get a response command that the configuration was successfully upgraded.
Example: _IUPDCFG: 0, Complete
To save or load a configuration using the web interface, see To save or load a
configuration on page 4-33.
98-148232-K
"ftp.myftpserver.com","ftp-username","ftp-
password"
The terminal will reboot when the configuration is updated.
Chapter 3: Operation
File transfer
3-26