COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 176

B.3.4 Context management AT commands
The table below summarizes some of the most used AT commands for context
management. Parameters are explained in the table in the next section. For details,
refer to the 3GPP standard TS 27.007.
Note
Command Parameters
+CGACT
+CGDCONT
+CGDSCON
T
+CGEQMIN
+CGEQREQ
+CGPADDR
+CGTFT
98-148232-K
The context management AT commands can only be used over a BGAN
connection and will not work on a cellular connection.
[<state>[,<cid>[,<cid>[,...]]]
[<cid>[,IP[,<APN>[,<PDP_addr>[,<d_comp>[,<h_comp>[,<apn
uname>,<apn_passwd>]]]]]]]
[<cid>,<p_cid>[,<d_comp>[,<h_comp>]]]
[<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate
DL>[,<Guaranteed bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery
order>[,<Maximum SDU size>[,<SDU error ratio>[,<Residual bit error
ratio>[,<Delivery of erroneous SDUs>[,<Transfer delay>[,<Traffic handling
priority>]]]]]]]]]]]]]
[<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate
DL>[,<Guaranteed bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery
order>[,<Maximum SDU size>[,<SDU error ratio>[,<Residual bit error
ratio>[,<Delivery of erroneous SDUs>[,<Transfer delay>[,<Traffic handling
priority>]]]]]]]]]]]]]
[<cid>[,<cid>[,...]]]
[<cid>[,<packet filter identifier>,<evaluation precedence index>[,<source
address and subnet mask>[,<protocol number (ipv4) / next header
(ipv6)>[,<destination port range>[,<source port range>[,<ipsec security
parameter index (spi)>[,<type of service (tos) (ipv4) and mask / traffic class
(ipv6) and mask>[,<flow label (ipv6)>]]]]]]]]]
Appendix B: Command reference
AT commands
B-18