COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 174

Parameter Values
<mode> 0
1
<passwd> <passwd>
<polarity> HIGH
LOW
<power down 0 - 1440
delay> (minutes)
<psmode> IDLE_TRG
TOD_TRG
WOL_STATUS
<psvalue> <idle-minutes>
<HH:MM>
0 or 1
<retr> 1 to 255
<retr_cell> 1 to 255
<intv_fail_cell 3 to 255
>
98-148232-K
Meaning
Only ping when no other traffic is observed.
Always ping (default).
The existing administrator password.
The Power control pin will be active high.
The Power control pin will be active low.
This is the time from when the Power control pin is deactivated until the
terminal enters power save state.
The power save mode is Idle power save and the trigger to set up is "idle
trigger", that is the time with no activity before entering power save
state.
The power save mode is Idle power save and the trigger to set up is
"time of day", that is a specific time of day (UTC time) where the
EXPLORER 540 wakes up from power save state.
The power save mode is Idle power save and the trigger to set up is
Wake-on-LAN. A "magic packet" received on the LAN interface wakes up
the terminal from power save state.
Used with IDLE_TRG (above). Number of minutes (e.g. 15).
Used with TOD_TRG (above). Time of day in UTC time (e.g. 23:30).
Used with WOL_STATUS (above). 0 is Off and 1 is On
Number of ping retries needed before determining the BGAN link is
down.
Default 3.
Number of ping retries needed before determining the Cellular link is
down.
Default 3.
Note that this setting is only applicable for EXPLORER 540 with Prism
capability. On any other terminal the argument is ignored.
Ping interval after first failure on Cellular connection.
Default 20.
Note that this setting is only applicable forEXPLORER 540 with Prism
capability. On any other terminal the argument is ignored.
Appendix B: Command reference
AT commands
B-16