COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 77

2. Select OK to reboot the terminal and start the installation process. Note that you
must log into the web interface with user name and password after reboot.
The BGAN signal strength is shown on the screen during the pointing process.
3. Turn and tilt the antenna slowly until you have obtained the highest possible signal
strength. You can use the pointing sound as well as the signal strength shown on
screen. For details, see Installation process for satellite operation on page 2-7.
4. When the EXPLORER 540 has detected a stable BGAN signal it automatically exits
the pointing process and starts to connect to the BGAN network.
• If you do nothing, the EXPLORER 540 automatically connects to the BGAN
network (if possible) and then completes the installation process.
• If you want to cancel installation and start over at next power-up, click Cancel.
You can still configure the EXPLORER 540, and the LED will be active.
If there are problems with the installation, the web interface will show a warning
icon next to the failing step in the installation window. The LED on the
EXPLORER 540 will be yellow (warning). See Troubleshooting guide on page 5-5.
5. Tighten the screws to fix the EXPLORER 540 in the pointed position.
6. When the installation process has ended, click Close to close the Installation
window.
98-148232-K Chapter 4: Configuration with web interface
To restart the installation process (BGAN)
4-13