COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 104

To set up remote access with IP
Note
1. From the Remote management page, select Enable access to web application
and/or Enable access to AT commands.
2. Type in the Incoming port numbers to use for the web server and for AT
commands.
The default port numbers are:
• web server: 80
• AT commands: 5454
Note
3. Under Trusted IP addresses, click Add IP address and type in the IP address of the
device you want to give access to the terminal.
4. To add more IP addresses, click Add IP address again.
5. Select Enable ping response if you want to enable the terminal to respond to ping
commands.
Note
After preparing the terminal and activating the connection you can access the terminal
from one of the trusted IP addresses, using the incoming port defined in the Incoming
port field.
• For information on how to prepare the terminal for remote activation of a data
connection, see the next section To set up remote access with SMS.
• For information on how to access the terminal, see To access the terminal from a
remote location on page 3-4.
If Static IP is included in your airtime subscription, we recommend using this static
public IP address for the terminal in order to provide easy access to the terminal. To
use the static IP address, it must be included in your airtime subscription and you must
set the APN source to SIM default. For details, see To change the APN for a connection
package on page 4-6.
To set up remote access with SMS
Note
1. From the Remote management page, select whether you want to Enable remote
SMS commands.
Note
98-148232-K
The settings for Remote access with IP are not relevant if you are using the
_IREMWEB command. See To use AT commands to get remote access to the
web interface on page 3-10.
If you type another port number, the port number must be available at
your service provider.
To be able to access the terminal you must have an active data connection.
The terminal must be registered to the satellite services to receive and accept
an SMS.
If you are using a cellular connection as your primary network connection,
the SMS commands will be sent over the BGAN backup connection. Note
that some SMS commands will not work, see Remote access with SMS on
page 3-4.
Chapter 4: Configuration with web interface
Advanced settings
4-40