COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 110

4.13.16 Reset button
You can change the function of the Reset button. See Reset button on page 5-4. Do as
follows:
1. From the Advanced page, select Reset Button.
2. Select the behavior you want for the Reset button.
• Enabled: Short push: The EXPLORER 540 restarts (power cycle) and begins the
installation process again, Long push: Reset to factory default.
• Long press disabled: The Reset button will not be able to reset to factory
default, but the short push function (power cycle) will still work.
• Disabled: The Reset button can only be used for safe mode (see Recovery
software update on page 5-2).
3. Click Save.
4.13.17 Security
To enable the use of Thrane IP Handset
The Thrane IP Handset is not relevant in M2M systems.
Important
For details, see To enable the use of Thrane IP Handset on page C-9 and the user
manual for the Thrane IP Handset.
To allow the use of AT commands on LAN interface
1. Under Advanced > Security, locate the field AT commands.
2. Select Allow on LAN interface if you want to allow the use of AT commands.
3. If you want users to be able to use AT commands on the LAN interface without
entering a password, remove the check mark at Require password.
By default, users must enter administrator password (with the _ICLCK command)
before they can send AT commands on the LAN interface.
4. Click Save.
HTTPS settings
The EXPLORER 540 internal web server supports HTTPS, which includes encryption of
the exchanged web traffic when accessing the EXPLORER 540 web interface.
By default, the system uses a self-signed certificate, but it also allows you to upload
your own certificate signed by a trusted Certificate Authority.
98-148232-K
This setting is disabled by default, and should be left disabled, if you do
not intend to use the Thrane IP Handset.
Chapter 4: Configuration with web interface
Advanced settings
4-46