Sms Remote Commands - COBHAM Satcom EXPLORER 540 User & Integrator's Manual

B.2 SMS remote commands
This section describes syntax and parameters for the SMS commands. For examples of
use, see Remote access with SMS on page 3-4.
B.2.1 Syntax conventions
Syntax definitions use the following conventions:
• <parm> indicates that a parameter (without < and >) can be filled in by the user.
• { <opt1> | <opt2> | ... | NA } indicates that one of various options must be chosen by
the user. Use NA when no value is defined.
• Keywords and parameters are separated by the space (ASCII 32) character.
• The command name and all keywords must be in upper case; most user-provided
parameters are case sensitive but may be either case.
• TE means Terminal Equipment - the equipment connected locally to the
EXPLORER 540.
B.2.2 SMS remote command summary
Commands
The table below summarizes the available SMS remote commands. The password
comes just after the last parameter (except for the ATCO command, see below). For
examples, see Remote access with SMS on page 3-4.
Command Parameters
ACTIVATE <qos> <PC/TE type> <apn> <user> <pwd>
ADPWRST 1 <imei>
ADVWATCHDOG <get/set> <wdog_enable> <wakeup> <interval> <ping1> <ping2> <ping3>
<apn_type> <apn> <user> <pwd> <pos_response> <sms_number>
CLEAR <category> SMS
DEACTIVATE <qos> <PC/TE type>
GETINFO <info_mode> <dataset>
RESTART <reset_type> BGAN
WATCHDOG <wdog_op> <ping1> <ping2> <ping3> <ping_always> <ping_interval>
<wdog_enable>
WANMODE <cmd_op> {<wanmode>}
SMS command for sending AT commands
ATCO <resp_mode> <rsms_pwd> <at_cmd>
98-148232-K Appendix B: Command reference

SMS remote commands

Password
<rsms_pwd>
<rsms_pwd>
<rsms_pwd>
<rsms_pwd>
<rsms_pwd>
<rsms_pwd>
<rsms_pwd>
<rsms_pwd>
<rsms_pwd>
B-4