COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 80

If you are not going to use a cellular network, leave this setting at BGAN only.
Internet and LAN connection modes
In the web interface you can set up the Internet connection mode and the IP
addressing between the EXPLORER 540 and devices connected to the EXPLORER 540.
The EXPLORER 540 has a built-in DHCP server which can be used to dynamically assign
IP addresses to devices connected to the EXPLORER 540.
The drawing below shows examples of the IP addressing in router mode (default
setup) and bridge mode.
192.168.0.n
Device 1
(assigned by the
terminal via DHCP)
192.168.0.m
Device 2
(assigned by the
terminal via DHCP)
192.168.0.n
Device 1
(assigned by the
terminal via DHCP)
161.30.181.130
Device 1
(assigned by the BGAN
network via DHCP)
98-148232-K
Router mode
(Default setup, example)
Terminal
192.168.0.1
192.168.0.1
Bridge mode, no connection to the BGAN network
(Example)
Terminal
DHCP
192.168.0.1
(Local IP address)
Bridge mode with active connection to the BGAN network
(Example)
192.168.0.1
(Local IP address)
Terminal
Chapter 4: Configuration with web interface
DHCP NAT
161.30.181.130
(assigned by the BGAN
network via DHCP)
Terminal settings
BGAN network
(DHCP server)
161.30.181.n
BGAN network
(DHCP server)
161.30.181.n
BGAN network
(DHCP server)
161.30.181.n
4-16