COBHAM Satcom EXPLORER 540 User & Integrator's Manual page 27

Audio assisted pointing
By default, the EXPLORER 540 uses a pointing sound to indicate the signal level during
the pointing procedure (Audio assisted pointing). The sound pattern is as follows:
• Poor signal strength:
• Good signal strength:
• Optimum signal strength:
"beeps")
You can disable the pointing sound using the web interface. For details, see To enable
or disable the pointing sound on page 4-18.
To repoint the antenna
You may need to point the antenna again later, e.g. if the terminal has been moved or
the signal is blocked.
To start the installation process again, you can do one of the following:
• Use the web interface (
installation process (BGAN) on page 4-12.
• Reset the EXPLORER 540 using the Reset button inside the interface enclosure on
the back of the terminal. See Reset button on page 5-4.
98-148232-K
• • • •
•••••••••••••••••••

(Control panel) and then Installation). See To restart the
Chapter 2: To get started
Installation process
(continuous sound instead of single
2-9