Omron CPM1 - PROGRAMING MANUAL 02-2001 Programming Manual page 227

Temperature Sensor Units
Programming with SCL2(––) Instruction (CPM2A/CPM2C Only)
25313
(Always ON Flag)
02000 Execution condition
Operation
3
IR 001
16 16
DM 0001
25506(=)
25506(=)
25506(=)
25504(CY)
25504(CY)
Binary to BCD conversion
2 1 0
16 16
0 0 0 1/0
1: Negative, 0: Non-negative
0: If data non-negative, "0000" stored in DM 0001
1: If data negative, "0001" stored in DM 0001
Detects completion of initialization.
CMP (20)
001
#7FFE
02000
ON when initialization complete.
Detects an open-circuit alarm.
CMP (20)
001
#7FFF
01000 ON when an open-circuit alarm has been detected.
SCL2 (–)
001
Parameter settings for data conversion:
DM0010
DM0000
DM0010
DM0011
DM0012
When the converted value is non-negative,
MOV (21)
stores #0000 in DM 0001.
#0000
DM0001
When the converted value is negative, stores
MOV (21)
#0001 in DM 0001.
#0001
DM0001
DM 0000
CY (when using SCL2 instruction)
3 2 1 0
10 10 10 10 1/0
Section 3-2
#0000 Offset
#0001 X (Hex)
#0001 Y (BCD)
207