Sv Change 2 - W - Omron CPM1 - PROGRAMING MANUAL 02-2001 Programming Manual

Host Link Commands
Parameters
4-5-18 SV CHANGE 2 – W$
Command Format
1 0
x 10 x 10
@ W
Node no. Header
code
Response Format
Parameters
292
Name, TC Number (Command)
In "Name," specify the name of the instruction, in four characters, for changing
the SV. In "TC number," specify the timer/counter number used for the instruc-
tion.
Instruction name
OP1 OP2
T I
T I
T I
T M
C N
C N
Changes the contents of the second word of the TIM, TIMH(15), TIML(––),
TMHH(––), CNT, or CNTR(12) at the specified program address in the user's
program. This can only be done with a program of less than 10K.
3 2 1 0
x 10 x 10 x 10 x 10
$
Program
address
OP1
Note TC number: 0000 to 0255 in CPM2A/CPM2C PCs and 0000 to 0127 in
CPM1/CPM1A/SRM1(-V2) PCs
An end code of 00 indicates normal completion.
x 10
@
Node no.
Name, TC Number (Command)
In "Name," specify the name of the instruction, in four characters, for changing
the SV. In "TC number," specify the timer/counter number used for the instruc-
tion.
Instruction name
OP1 OP2
T I
T I
T I
T M
C N
C N
OP3 OP4
M (Space)
M H
M L
H H
T (Space)
T R
OP1 OP2 OP3 OP4 x 10
Name
3
OP2 OP3 OP4 x 10 x 10
Operand
1 0 1
x 10 x 16
W $
Header End code
code
OP3 OP4
M (Space)
M H
M L
H H
T (Space)
T R
Section
Classification
TIMER
HIGH-SPEED TIMER
LONG TIMER
VERY HIGH-SPEED TIMER
COUNTER
REVERSIBLE COUNTER
3 2 1 0
x 10 x 10 x 10
TC number
2 1 0 :
x 10 x 10
SV FCS Terminator
:
0
x 16
FCS Terminator
Classification
TIMER
HIGH-SPEED TIMER
LONG TIMER
VERY HIGH-SPEED TIMER
COUNTER
REVERSIBLE COUNTER
4-5