Orientalmotor AZX Series Operating Manual page 59

When the "AREA range setting mode" parameter is "1: Offset/width setting from the target position"
Motor operation
ON
AREA output
OFF
z FW-SLS output, RV-SLS output
If the command position exceeds the range set in the "Software limit" parameter when the "Software overtravel"
parameter is set to other than "−1 Disable," the FW-SLS output or the RV-SLS output is turned ON.
z RND-OVF output
ON-OFF of the RND-OVF output is inverted when the wrap range is exceeded.
„ Coordinate status indication
z ABSPEN output
The ABSPEN output is turned ON when the coordinates are set.
z PRST-DIS output
The PRST-DIS output is turned ON when the home is required to set again.
If the "Preset position" parameter is set to other than "0," the PRST-DIS output is turned ON when the resolution is
changed after position preset or return-to-home operation is performed.
When the PRST-DIS output has been turned ON, perform position preset or return-to-home operation to set the
home.
If the resolution is changed in a state where the "Preset position" parameter is set to "0," coordinates
are automatically set again. Therefore, the PRST-DIS output is not turned ON even if the resolution is
changed.
z PRST-STLD output
The PRST-STLD output is turned ON when position preset is performed and the home information is stored in the
ABZO sensor.
z ORGN-STLD output
Products such as motorized actuators whose home is set at the time of factory shipment are delivered in a state where
the ORGN-STLD output is ON.
O set
Width Width
Output signals
59