Wire Feeder Settings View - Kemppi X8 MIG Welder Operating Manual

The welding parameter shown is Wire feed speed, Current or Plate Thickness.
Fine tune the secondary welding parameter with the right control knob. The adjustable secondary parameter varies
according to the welding process and function.
Memory Channels view
Welding parameters are stored in the memory channels. The memory channel displays the same information of the weld-
ing parameters as the Welding view. Each user has their own memory channels.
Press the Channel button on the left to see the Channel view. A menu of the memory channels appears on the left side
of the display. To take a channel into use, move focus to it with the right control knob. A tilted number of the memory
channel indicates that the parameters of the original memory channel have been modified.
To save a modified channel, press and hold the Channel button or press Save on the green button of the right knob.
Settings view
For more information on wire feeder's settings, see "Wire feeder settings view" below.

Wire feeder settings view

You can adjust the selected memory channel or the settings of the wire feeder through the Settings view.
Press the Settings button to access the wire feeder settings. When the settings view is open, the Settings button lights
up orange.
Modify the parameters with the right knob. Press the green button in the center of the knob to select and turn the right
knob to adjust a parameter.
Table 1. Wire feeder settings:
Trigger
WP Switch ON/OFF
Dynamics
Touch sense ignition
Hot start
Crater fill
Weld data
Device information
Wireless devices
© Kemppi
Change the welding gun trigger mode (2T/4T).
Switch the WP Switch feature ON or OFF.
Adjust the dynamics setting for MIG, 1-MIG, Pulse, DPulse and WiseThin+.
DPulse and WP Switch also have a Dynamics2 setting for adjusting the second
level dynamics.
Switch the optimized ignition feature ON or OFF.
Switch the HotStart feature ON or OFF.
Switch the crater fill feature ON or OFF.
Shows you the information on the latest weld.
Press the green button on the right knob to view more information.
Shows you the serial number and software versions of the welding system.
Press the green button on the right knob to view more information.
Press the Connect button on the right to set a wireless connection to Control
Pad.
72
X8 MIG Welder
Operating manual - EN
1902370 / 2324