Power Source Installation; Installing Wheels - Kemppi X8 MIG Welder Operating Manual

2.2 Power source installation

For power source cable connections, see "Installing interconnection cable" on page 43 and "Installing or replacing mains
cable" on page 30. For operating the power source, see "Preparing welding system for use" on page 73.
"Installing wheels" below
"Installing optional gas cylinder cart" on page 26
"Installing optional X8 Cooler" on page 29
"Installing or replacing mains cable" on page 30

2.2.1 Installing wheels

To have turning wheels in the front and the back, install the front wheel assembly to the front of the unit. To have fixed
wheels in the front, install the rear wheel assembly to the front of the unit. See also "Installing optional gas cylinder cart"
on page 26.
Proceed as follows:
Install the rear wheels:
1. Remove the packaging from the sides but leave the power source resting on the pallet.
© Kemppi
23
X8 MIG Welder
Operating manual - EN
1902370 / 2324