Digital Wps: Selecting Wps Pass In Wps View - Kemppi X8 MIG Welder Operating Manual

If the WPS includes several passes, select the pass in Active pass. See "Digital WPS: selecting WPS pass in WPS view"
below.
5. Press a view button to leave the WPS view.
You can also change WPS or the pass in Channel view. See "Digital WPS: selecting WPS or pass in channel view" on
the next page.

Digital WPS: selecting WPS pass in WPS view

Proceed as follows:
1. Go to the View menu > WPS.
>> Control Pad shows the active WPS in the WPS view.
>> If there is no active WPS, Control Pad shows the WPS list. Select the WPS.
2. Move focus to Active pass.
>> The information under Active pass is pass-specific and varies according to the pass.
© Kemppi
108
X8 MIG Welder
Operating manual - EN
1902370 / 2324