X8 Wire Feeder - Kemppi X8 MIG Welder Operating Manual

7. Coolant circulation warning
>> The LED is green when the coolant circulation is working normally.
>> The LED is red when there is a problem in the coolant circulation.
>> The LED blinks green and red in turns when the circulation of the coolant liquid has been obstructed too long.
If the circulation of the coolant liquid is obstructed, a thermal cutoff switches the welding system off. Check and fix
the error before using the welding system again.
If the error was caused in an unsuccessful filling of the cooler, refill the cooler. In other cases, the error disappears
automatically in 30 seconds.
8. Wireless pairing button
>> To pair the wire feeder or power source with Control Pad, press the button. If the power source is connected to
wire feeder(s), the wire feeder(s) pairs with Control Pad. If the power source is not connected to a wire feeder,
the power source pairs with Control Pad.
>> The LED is blue when the wire feeder or power source is wirelessly connected to Control Pad.
>> The LED blinks blue when the wire feeder or power source is pairing with Control Pad.
Interconnection cable
1. Shielding gas hose
2. Coolant inlet hose
3. Coolant outlet hose
4. Welding current cable
5. Control cable
6. Measurement cable
7. Strain relief pin.

1.2.2 X8 Wire Feeder

This section describes the structure of X8 Wire Feeder.
© Kemppi
13
X8 MIG Welder
Operating manual - EN
1902370 / 2324