Table of Contents
Advertisement
4.
Measurement cable connectors
>> Connectors for wire feeder 1 on the left, wire feeder 2 on the right side of the power source.
5.
Control cable connectors
>> Connectors for wire feeder 1 on the left, wire feeder 2 on the right side of the power source.
6.
Ethernet connector
7.
Power switch
8.
Coolant outlet hose connector
9.
Coolant inlet hose connector
10. Rear panel
11. Mains cable
12. Strain relief holder
Indicator panel
1.
Power indicator
>> The LED is green when the unit is on.
2.
Voltage Reduction Device (VRD) indicator
>> The LED is green when VRD is switched on and the no-load voltage is under 35 V.
>> The LED blinks red when VRD is switched on and the no-load voltage is above 35 V.
>> The LED is off when VRD is switched off or during welding.
VRD is in use with MMA and Gouging modes only.
3.
Overheat indicator
>> The LED is yellow when the unit is overheating.
If the power source overheats, a thermal cutoff switches the unit off and does not allow it to be used until it has
cooled down.
4.
Kemppi cloud connection
>> The LED is blue when the wire feeder or power source is connected to Kemppi cloud services.
>> The LED blinks blue when the wire feeder or power source is connecting to Kemppi cloud services.
5.
Coolant level warning
>> The LED is yellow when the coolant level is too low.
6.
Coolant temperature warning
>> The LED is yellow when the cooler is overheating.
If the coolant liquid overheats, a thermal cutoff switches the welding system off and does not allow it to be used
until the coolant liquid has cooled down.
© Kemppi
12
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
